Intake Camshaft Removal
WARNING: This page is about a different variant/trim than selected.
-
Courtesy of GENERAL MOTORS COMPANY
NOTE:Many internal engine components will develop specific wear patterns on their friction surfaces.
- The components MUST be separated, marked, or organized in a way to ensure the installation to their original location and position. Take precautions in order to prevent interchanging of parts.
- Tag or mark each part immediately when removed. Indicate the location, direction, or orientation when necessary.
- Loosen the 10 camshaft bearing cap bolts (1) in sequence as shown in steps of 1/2 turn.
Camshaft Bearing Cap Bolt (2) - Remove [10x]
- Camshaft Bearing Front Cap (1) - Remove
- Camshaft Bearing Cap (3) - Remove [4x]
- Intake Camshaft (4) - Remove
Hydraulic Valve Lash Adjuster Arm (1) - Remove [6x]
- Hydraulic Valve Lash Adjuster (2) - Remove [6x]