LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Trailblazer RS, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 1.2L (LIH)) >> Repair Instructions >> Engine Mount Brace Replacement (Rear) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM5607969Courtesy of GENERAL MOTORS COMPANY

    Engine Mount Brace (3) - Install

  2. Engine Mount Brace Bolt (2) - Install NEW and hand tighten I
    3. CAUTION:

    Refer to Fastener Caution .

    CAUTION:

    Torque-to-Yield Fastener Warning

  3. Engine Mount Brace Bolt (2) - Tighten in the following sequence
    1. First Pass: 100 N.m (74 lb ft)
    2. Final Pass: 90 - 105 degrees
  4. Engine Mount Brace Bolt (1) - Install and tighten [2x] 22 N.m (16 lb ft)
  5. Remove the jack stand.
  6. Front Compartment Insulator - Install - Front Compartment Insulator Replacement (Base)
scientia non olet · About LEMON Manuals