Engine Block Disassemble
WARNING: This page is about a different variant/trim than selected.
-
Courtesy of GENERAL MOTORS COMPANY
Cylinder Head Locating Pin (1) - Remove [2x]
- Engine Block Oil Gallery Plug (3, 6) - Remove [3x]
- Engine Front Cover Locating Pin (2, 4) - Remove [2x]
- Engine Block Oil Gallery Plug (5) - Remove [3x]
- Bolt (7) - Remove
- Engine Coolant Heater (8) - Remove
-
Courtesy of GENERAL MOTORS COMPANY
Engine Oil Pressure Sensor (1) - Remove
- Seal (2) @ Engine Oil Pressure Sensor - Remove and DISCARD
- Engine Block Oil Gallery Plug (4) - Remove [2x]
- Transmission Locating Pin (3, 6) - Remove [2x]
- Crankshaft Rear Oil Seal Housing Locating Pin (5) - Remove [2x]
- Starter Locating Pin (7) - Remove [2x]
- Knock Sensor Bolt (8) - Remove
- Knock Sensor (9) - Remove
Piston Oil Nozzle Bolt (1) - Remove [3x]
- Piston Oil Nozzle (2) - Remove [3x]