Cleaning Procedure
WARNING: This page is about a different variant/trim than selected.
- Remove any old thread sealant, gasket material or sealant.
- Clean all the following areas with solvent:
- Sealing surfaces
- Cooling passages
- Oil passages
- Bearing journals
- Clean all threaded and through holes with solvent.
- Dry the engine block with compressed air.
NOTE:
DO NOT allow cleaning solvents to come in contact with either the timing belt or oil pump belt. Ensure both belts are set aside in a location away from cleaning solvents.
WARNING:
Wear safety glasses when using compressed air in order to prevent eye injury.