Crankshaft Balancer Removal

Special Tools 

EN-52476  Flywheel Locking Tool

Equivalent regional tools: Special Tools 

1. Courtesy of GENERAL MOTORS COMPANY

   NOTE:

   Ensure the EN-52476  Flywheel Locking Tool (1) is properly assembled, and the timing pin plunger (3) is retracted. When using the EN-52476  Flywheel Locking Tool as a locking device, adjust the pawl armature (4) to fully engage the teeth once installed.

   EN-52476  Flywheel Locking Tool (1) - Install

2. Bolt (2) - Install and tighten [2x]
3. Adjust the pawl armature (4) on the EN-52476  Flywheel Locking Tool to fully engage the teeth.

4. Courtesy of GENERAL MOTORS COMPANY

   Crankshaft Balancer Bolt (3) - Remove and DISCARD

5. Crankshaft Balancer (1) - Remove
6. EN-52476  Flywheel Locking Tool - Remove