Camshaft Cover Installation

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Oil Filler Cap (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Camshaft Cover Gasket (3) - Install NEW

NOTE:

Check that the locating pins (2, 4) sit correct in their hole.

Camshaft Cover (1) - Install
Fig 1: Identifying Camshaft Cover Bolts With Tightening Sequence
Courtesy of GENERAL MOTORS COMPANY

Camshaft Cover Bolt (1) - Install and hand tighten [17x]

CAUTION:

Component Fastener Tightening Caution

Camshaft Cover Bolt (1) - Tighten in sequence [17x]
1. First Pass: 4 N.m (35 lb in)
2. Final Pass: 8.5 N.m (75 lb in)
Courtesy of GENERAL MOTORS COMPANY

Oil Level Indicator (1) - Install