Automatic Transmission Flex Plate Removal

WARNING: This page is about a different variant/trim than selected.

Special Tools

EN-52476 Flywheel Locking Tool

Equivalent regional tools: Special Tools

Courtesy of GENERAL MOTORS COMPANY

NOTE:
Ensure the EN-52476 Flywheel Locking Tool (1) is properly assembled, and the timing pin plunger (3) is retracted. When using the EN-52476 Flywheel Locking Tool as a locking device, adjust the pawl armature (4) to fully engage the teeth once installed.

EN-52476 Flywheel Locking Tool (1) - Install
Bolt (2) - Install and tighten [2x]
Adjust the pawl armature (4) on the EN-52476 Flywheel Locking Tool to fully engage the teeth.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Ensure the EN-52476 Flywheel Locking Tool timing pin plunger remains retracted during bolt removal and installation. Ensure the pawl armature is fully engaged to the teeth and the armature is secured.

Automatic Transmission Flex Plate Bolt (2) - Remove and DISCARD [6x]
Automatic Transmission Flex Plate (1) - Remove