LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Trailblazer RS, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 1.2L (LIH)) >> Diagnostic Information and Procedures >> DTC P06DA-P06DE >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
NOTE:

The engine oil level and condition is critical to the correct operation of the system.

  1. Ignition - On / Vehicle - In Service Mode
  2. Verify the scan tool parameter:
    • Engine Oil Pressure Control Solenoid Valve Control Circuit High Voltage Test Status = Not Run or OK
    • Engine Oil Pressure Control Solenoid Valve Control Circuit Low Voltage Test Status = Not Run or OK
    • Engine Oil Pressure Control Solenoid Valve Control Circuit Open Test Status = Not Run or OK
    • If not the specified state 

      Refer to Circuit/System Testing

    • Go to next step: If the specified state 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify the DTC does not set.

    • If the DTC sets 

      Refer to Circuit/System Testing

    • Go to next step: If the DTC is not set 
  4. All OK.