Removal Procedure
The battery must be disconnected to prevent the brake master cylinder from pressurizing the hydraulic system during its automated self diagnostic tests that can possibly occur when a door is opened or the key transmitter is activated. Failure to follow this precaution may cause personal injury.
Do NOT clamp the brake master cylinder reservoir tube to stop the flow of brake fluid. Doing so could cause damage to the tube, degradation of braking performance, and potential loss of brakes. Failure to follow this warning may cause component damage or personal injury.
- Drain and properly dispose of the brake fluid in the master cylinder reservoir.
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
Electrical Connector (1) @ Brake Fluid Level Indicator Switch (2) - Disconnect
- WARNING:
Do NOT clamp the brake master cylinder reservoir tube to stop the flow of brake fluid. Doing so could cause damage to the tube, degradation of braking performance, and potential loss of brakes. Failure to follow this warning may cause component damage or personal injury.
Quick Connect Fitting (1) @ Brake Master Cylinder - Disconnect
Brake Master Cylinder Reservoir Bracket Nut (1) - Remove [2x]
- Brake Master Cylinder Reservoir- Upper (2) - Remove
- Transfer components as necessary.