Park Brake Calibration

The park brakes do not require calibration often. Park brake calibration may be required after certain service procedures are performed. Some of these procedures are as follows:

• Park brake actuator replacement.
• Front brake pad replacement.
• Front brake rotor replacement.
• Front brake caliper replacement.

The park brake calibration procedure can be completed using the following steps:

1. Block the drive wheels.
2. Install a scan tool to the vehicle.
3. Turn the ignition switch to the ON/RUN position with the engine OFF.
4. Select Configuration/Reset Functions from the Brake System Control Module menu.
5. If available, perform the Parking Brake Calibration procedure.
6. If Park Brake Calibration is not available, proceed back and select Control Functions.
7. Perform the Front Brake Caliper Piston Extend function.
8. Apply and release the park brakes using the park brake switch to ensure that the system is functioning.