Removal Procedure
WARNING:
The battery must be disconnected to prevent the brake master cylinder from pressurizing the hydraulic system during its automated self diagnostic tests that can possibly occur when a door is opened or the key transmitter is activated. Failure to follow this precaution may cause personal injury.
WARNING:
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Battery Tray - Remove - Battery Tray Replacement
- Raise and support the vehicle. Lifting and Jacking the Vehicle .
- Remove the left front and right rear tires. Tire and Wheel Removal and Installation
- Fuel Tank - Remove - Fuel Tank Replacement (AWD) , or Fuel Tank Replacement (FWD)
Rear Brake Intermediate Pipe Fitting (1) @ Brake Pressure Modulator Valve - Remove
- Cap the brake pipe fitting and plug the brake pressure modulator valve port to prevent brake fluid loss and contamination.
- Brake Pipe Clip (2) - Release
Brake Pipe Clip (1) - Release
Rear Brake Intermediate Pipe Fitting (1) @ Brake Pipe Union (2) - Remove
- Cap the brake pipe fitting to prevent brake fluid loss and contamination.
Brake Pipe Clip (1) - Release
- Brake Pipe Clip (2) - Release
- Brake Pipe Clip (3) - Release
- Brake Pipe Clip (4) - Release
Brake Pipe Clip (1) - Release [5x]
- Rear Brake Intermediate Number 2 Pipe (2) @ Vehicle - Remove