LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Trailblazer ACTIV, FWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Brake and Accelerator Pedal Assembly Replacement >> Removal Procedure

Removal Procedure

  1. Battery Tray - Remove - Battery Tray Replacement
  2. GM5225124Courtesy of GENERAL MOTORS COMPANY

    Instrument Panel Tie Bar Bolt (1) - Remove

  3. Steering Column - Remove - Steering Column Replacement
  4. GM5225125Courtesy of GENERAL MOTORS COMPANY

    Instrument Panel Tie Bar Bolt (1) - Remove [4x]

  5. Wiring Harness Retainer @ Steering Column Bracket - Release
  6. Steering Column Bracket (2) @ Instrument Panel Tie Bar - Remove
  7. GM5225127Courtesy of GENERAL MOTORS COMPANY

    Electrical Connector (1) @ Accelerator Pedal Position Sensor - Disconnect

  8. Electrical Connector (2) @ Brake Pedal Position Sensor - Disconnect
  9. Wiring Harness Retainer @ Brake and Accelerator Pedal Bracket - Release [3x]
  10. GM5225117Courtesy of GENERAL MOTORS COMPANY

    Brake Pedal Push Rod (3) @ Brake Pedal (2) - Disconnect

    Release the 2 retainer tabs and pull the brake pedal a bit to facilitate the removal.

  11. Brake Pedal Push Rod Retainer (1) @ Brake Pedal Push Rod (3) - Remove and DISCARD
  12. GM5225128Courtesy of GENERAL MOTORS COMPANY

    Brake and Accelerator Pedal Bracket Nut (1) Remove [5x]

  13. Wiring Harness Retainer @ Brake and Accelerator Pedal Assembly - Release
  14. Brake and Accelerator Pedal Assembly (2) Remove
  15. Transfer components as necessary.
scientia non olet · About LEMON Manuals