LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Trailblazer ACTIV, 4WD >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Interior Trim And Paneling >> Repair Instructions >> Windshield Garnish Molding Replacement

Windshield Garnish Molding Replacement

GM5163411Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
CAUTION:

If a vehicle is equipped with a head curtain inflator module ensure that the inflator module and tether are undamaged. If tether or curtain airbag are damaged in any way, they must be replaced.

CAUTION:

Use care when working around the head curtain inflator module. Sharp tools may puncture the curtain airbag. If the head curtain inflator module is damaged in any way, it must be replaced.

Preliminary Procedure Disable the SIR system. SIR Disabling and Enabling
1 Windshield Garnish Molding
Procedure 
Pull the windshield garnish molding rearwards to release the tether from the A pillar.
2 Windshield Garnish Molding Bolt
CAUTION:

Fastener Caution

Procedure

  1. Access the bolt which is located on the backside of the garnish molding and secures the tether to the A pillar.
  2. Disconnect the electrical connector.
  3. Enable the SIR System. SIR Disabling and Enabling
NOTE:

Tether and Bolt are integral to the Windshield Garnish Molding.


Tighten 
2.5 N.m (22 lb in)
scientia non olet · About LEMON Manuals