Windshield Wiper Arm Replacement

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Open and support the hood.
1	Windshield Wiper Arm Finish Cap
2	Windshield Wiper Arm Nut CAUTION: Fastener Caution Tighten 25 N.m (18 lb ft)
3	Windshield Wiper Arm Procedure Use the BO-49385 wiper arm puller, remove the wiper arm from the wiper system module pivot shaft. Transfer components as necessary. Windshield Wiper Arm - Adjust - Windshield Wiper Arm Adjustment Special Tools BO-49385 wiper arm puller Equivalent regional tools: Special Tools