Installation Procedure
Remove the instrument panel cluster applique (2) to the instrument panel steering column upper trim cover (1) using a flat bladed plastic trim tool.
Install the instrument panel steering column upper trim cover (1) to the vehicle using a flat bladed plastic trim tool.
- CAUTION:
Refer to Fastener Caution .
Instrument Panel Steering Column Upper Trim Cover Bolt (1) - Install and tighten [2x] 2.5 N.m (22 lb in)
Push the instrument panel steering column upper trim cover (1) carefully against the direction of the arrows.
Instrument Panel Lower Center Trim Plate Applique (1) - Install - Instrument Panel Lower Center Trim Plate Applique Replacement
Instrument Panel Switch Trim Plate (2) - Install - Instrument Panel Switch Trim Plate Replacement
Instrument Panel Knee Bolster (1) - Install - Instrument Panel Knee Bolster Replacement
Push the instrument panel steering column upper trim cover (1) carefully against the direction of the arrows.
- Rotate the steering wheel 180 degrees, to repeat the procedure on the other side.