Removal Procedure
- Transmission - Remove - Automatic Transmission Removal and Installation (L84, L87 with 4WD and NP0) , or Automatic Transmission Removal and Installation (L84, L87 with 4WD and NQH)
Position EN-42386 Flywheel Holding Tool (1) into place.
- Install M10-1.5 x 120mm (3) and M10-1.5 x 45mm (2) bolts and tighten to 50 N.m (37 lb ft).
- NOTE:
Note the position and direction of the automatic transmission flex plate before removal.
Automatic Transmission Flex Plate Bolt (1) - Remove and DISCARD [8x]
Automatic Transmission Flex Plate (1) - Remove