Removal Procedure

Open the liftgate window.

Courtesy of GENERAL MOTORS COMPANY
Use a small flat-bladed tool to remove the 2 panel locators (1).
Liftgate Lower Trim Finish Panel Access Hole Cover (2) - Remove
Use the appropriate trim tool to release the liftgate upper center trim finish panel (1) from the liftgate inner panel.

Courtesy of GENERAL MOTORS COMPANY
Liftgate Upper Center Trim Finish Panel (1) - Remove
Use a flat-bladed trim tool to aid in the removal of the liftgate upper side trim finish panels (1) from the liftgate.

Courtesy of GENERAL MOTORS COMPANY
Liftgate Upper Side Trim Finish Panel (1) - Remove [2x]
Use a flat-bladed trim tool to aid in the removal of the rear compartment lid inner panel trim hole plug (1).

Courtesy of GENERAL MOTORS COMPANY
Liftgate Lower Trim Finish Panel Bolt (2) - Remove
Disconnect the electrical connector.
Liftgate Lower Trim Finish Panel (3) - Remove
Reposition the liftgate weatherstrip and headliner as needed to gain access to electrical connections.

Courtesy of GENERAL MOTORS COMPANY
Disconnect the electrical connectors and wire harness retainers as needed.
Liftgate Wiring Harness (1) - Remove