Installation Procedure
- Liftgate Hinge (2) - Install
- Liftgate Hinge Nut (1) - Install and tighten [2x] - Fastener Specifications
- Liftgate Hinge Bolt (1) - Install and tighten [2x] - Fastener Specifications
- Remove liftgate support.
- Rear Compartment Lift Window (1) - Install
- With aid of assistance, lift and slid the rear compartment lift window (1) to the right and onto the hinge pins (2).
- Install the liftgate hinge pin retainers (1).
- Connect the liftgate window struts to the rear compartment lift window.
- Rear Window Defroster Electrical Connector (2) - Connect [2x]
- Rear Window Defroster Electrical Connector Trim Cover (1) - Install [2x]
- Rear End Spoiler (1) - Install
- Rear End Spoiler Bolt (2) - Install and tighten [11x] - Fastener Specifications
- Rear End Spoiler Bolt (1) - Install and tighten [4x] - Fastener Specifications
- Connect all electrical connectors.
- Rear Window Washer Nozzle Hose Extension - Connect
- Connect the liftgate upper panel grommet.
- Engage the retaining clips (2) at the rear underside of the headlining trim panel (1).
- Headlining Trim Panel (1) - Install
- Engage the 2 body rear corner upper garnish molding (1) and retaining clips.
- Body Rear Corner Upper Garnish Molding- Left Side and Right Side (1) - Install
- Body Rear Corner Upper Garnish Molding Bolt- Left Side and Right Side (1)Install and tighten Fastener Specifications
- - Left Side and Right Side (2) - Install
- Body Side Rear Window Garnish Molding Bolt- Left Side and Right Side (1) - Install and tighten - Fastener Specifications
- Engage the body side rear window garnish molding (1) and retaining clips on both sides.
- Body Side Rear Window Garnish Molding- Left Side and Right Side (1) - Install
- Liftgate Weatherstrip (1) - Install
- Confirm function of high mount stop lamp and washer nozzle.
- Adjust liftgate as necessary.
- Perform the necessary programming and setup procedure: Liftgate Calibration
CAUTION:
Refer to Fastener Caution .