Removal Procedure
- Hood Latch Actuator Bolt (1) - Remove [2x]
- Hood Secondary Latch Release Handle (2) - Remove
- Intake Air Baffle Retainer (1) - Remove [9x]
- Intake Air Splash Shield (2) - Remove
- Hood Primary and Secondary Latch Bolt (1) - Remove [2x]
- Hood Primary and Secondary Latch (2) - Remove
- Disconnect the hood primary latch release cable (3) from the hood primary latch.
- Release the retainer under the tie bar and disconnect the electrical connector.
- Reposition the hood primary latch release cable (1) from the upper tie bar.
- Front Bumper Fascia (2) - Remove - Front Bumper Fascia Removal and Installation (with RC1)Front Bumper Fascia Removal and Installation (with WTX)
- Headlamp Bolt- Left Side and Right Side (1) - Remove [6x]
- Headlamp Bolt- Left Side and Right Side (1) - Remove [6x]
- Release the front headlamp guide pin from the front bumper fascia guide (1).
- Front Headlamp- Left Side and Right Side (2) - Remove [2x]
- Release the wiring harness retaining tab
- Disconnect all electrical connectors.
- Loosen the left and right side front bumper fascia upper stiffener nut (1).
- Remove the left and right side front bumper fascia upper stiffener bolt (2).
- Pull the front bumper fascia upper stiffener (1) up and out over the stud.
- Ambient Air Temperature Sensor (1) - Remove
- Disconnect the electrical connector. (2)
- Front Bumper Shutter Retainer (1) - Remove [3x]
- Front Bumper Shutter Bolt (1) - Remove [9x]
- Front Bumper Shutter (2) - Remove
- Front Grille Support Bracket Bolt (1) - Remove [4x]
- Front Grille Support Reinforcement (2) - Remove
- Front End Upper Tie Bar Bolt (1)@Headlamp Bracket - Remove [8x]
- Headlamp Bracket (2) - Remove [2x]
- Intake Air Duct Retainer (1) - Remove
- Intake Air Duct (2) - Remove
- Front End Sheet Metal Diagonal Brace Bolt (1) - Remove [4x]
- Front End Sheet Metal Diagonal Brace@Radiator (2) - Remove [2x]
- Front End Sheet Metal Diagonal Brace Bolt (1) - Remove [4x]
- Front End Sheet Metal Diagonal Brace@Upper Tie Bar (2) - Remove [2x]
- Radiator Air Upper Baffle (1) - Remove
- Horn Nut (1) - Remove
- Dual Horn (2) - Remove
- Disconnect the electrical connector.
- Front End Upper Tie Bar Bolt (1) - Remove [3x]
- Front End Upper Tie Bar Bolt (1) - Remove
- Front End Upper Tie Bar Bolt (1) - Remove [3x]
- Front End Upper Tie Bar Bolt (1) - Remove
- Disconnect the wiring harness retainers and reposition the harness as necessary.
- Front End Upper Tie Bar (1) - Remove