Fuel Level Gauge

The instrument cluster displays the fuel level based on the information from the ECM. The ECM converts the data from the fuel level sensors to a fuel level signal. The ECM sends the fuel level signal via a High Speed CAN-Bus signal to the BCM. The BCM then sends the information via a Low Speed CAN-Bus signal to the instrument cluster to display the fuel level. FILL FUEL is displayed when the fuel level reaches approximately 8% of fuel capacity and remains on until fuel level is increased above 8%. If FILL FUEL message is displayed, the DIC buttons are disabled. The fuel gauge defaults to empty if:

• The ECM detects a malfunction in the fuel level sensor circuit.
• The BCM detects a loss of serial data communications with the ECM.
• The instrument cluster detects a loss of serial data communications with the BCM.