Component Testing

Relay Test

1. Ignition/Vehicle - Off
2. Remove the appropriate component:
   • KR27C Starter Pinion Solenoid Actuator Relay
   • KR27 Starter Relay
3. Test for 70 to 110 ohms between the test points: Component terminal 85 & 86
   • If not between 70 and 110 ohms 

     Replace the appropriate component: KR27C Starter Pinion Solenoid Actuator Relay or KR27 Starter Relay

   • Go to next step: If between 70 and 110 ohms 
4. Test for infinite resistance between the test points:
   • Component terminal 30 & 85
   • Component terminal 30 & 86
   • Component terminal 30 & 87
   • Component terminal 85 & 87
   • Component terminal 86 & 87
   • If less than infinite resistance 

     Replace the appropriate component: KR27C Starter Pinion Solenoid Actuator Relay or KR27 Starter Relay

   • Go to next step: If infinite resistance 
5. Connect a 3 A fused jumper wire between the test points: Component terminal 86 & 12 V

   Connect a jumper wire between the test points: Component terminal 85 & Ground

6. Test for less than 2 ohms between the test points: Component terminal 30 & 87
   • If 2 ohms or greater 

     Replace the appropriate component: KR27C Starter Pinion Solenoid Actuator Relay or KR27 Starter Relay

   • Go to next step: If less than 2 ohms 
7. All OK.