Conditions for Setting the DTC
DTC P3051
Control module K20 ECM detects: DC/DC Converter Output Voltage Sensor Circuit 1 Low Voltage - Less than 1 V
DTC P3053
Control module K20 ECM detects: DC/DC Converter Output Voltage Sensor Circuit 1 High Voltage Greater than 28 V
DTC P3055
Control module K20 ECM detects: A difference of greater than 1 V between the ECM IGN voltage and the DC/DC converter output voltage when the engine is running or A difference of greater than 2 V between the ECM IGN voltage and the DC/DC converter output voltage when compared to the pre cranking voltage snapshot during the restart during an Autostart/Autostop Event.