Diagnostic Aids
- A high or low voltage DTC set or voltage value in multiple modules/sensors indicates a concern in the charging system.
- A possible cause of this DTC could be overcharging with a battery charger or jump starting.
- A possible cause of this DTC is a discharged battery or a poor/intermittent connection at X1 B110 Battery Monitor Module.
- The device is connected to the LIN bus, if there is a fault in another device on the LIN bus it can cause the B110 Battery Monitor Module to set intermittent false codes.
- A loose battery clamp to post connection can cause B110 Battery Monitor Module DTCs to set.
- The last 2 digits of the circuit number are significant in identifying its power and ground functions.
- Circuits ending in 42 are primary fused B+ circuits (generally the first fuse in the circuit after the battery)
- Circuits ending in 40 are secondary fused circuits (generally fuses in a fuse block after the primary circuit)
- Circuits ending in 39 and 41 are ignition voltage circuits.
- Circuits ending in 50 are grounds.
- Circuits ending in 51 are low reference (ground) circuits.