Removal Procedure
WARNING:
WARNING:
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Tire and Wheel Removal and Installation - Remove
- Disconnect the park brake cable from the brake caliper actuator lever. - Parking Brake Rear Cable Replacement - Left Side , Parking Brake Rear Cable Replacement - Right Side
Brake Hose Fitting Bolt (1) - Remove
- NOTE:
Do NOT reuse the brake hose fitting gaskets.
Brake Hose Fitting Gasket (1) @ Brake Hose Fitting (2) - Remove and DISCARD [2x]
- Cap the brake hose fitting to prevent brake fluid loss and contamination.
Brake Caliper Guide Pin Bolt (1) - Remove [2x]
Brake Caliper (1) - Remove