Installation Procedure
- Thoroughly clean the brake caliper bracket guide pin bores with denatured alcohol and allow to dry.
Caliper Lower Guide Pin Bushing (1) - Install
- Apply a light coat of high temperature silicone brake lubricant to the caliper guide pins.
Caliper Lower Guide Pin (1) - Install
- Ensure the guide pin seal is fully seated in the groove of the caliper guide pin.
- Gently lift the edge of the guide pin seal while pushing the guide pin into the caliper bracket bore to expel any trapped air.
Caliper Upper Guide Pin (1) - Install
- Ensure the guide pin seal is fully seated in the groove of the caliper guide pin.
- Gently lift the edge of the guide pin seal while pushing the guide pin into the caliper bracket bore to expel any trapped air.
Rear Brake Caliper (1) - Install
- CAUTION:
Brake Caliper Guide Pin Bolt (1) - Install and tighten 40 N.m (30 lb ft) [2x]
- Tire and Wheel Assembly - Install - Tire and Wheel Removal and Installation
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (Without KL9) , or Battery Negative Cable Disconnection and Connection (With KL9)