Rear Seat Back Bolster Replacement

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
WARNING: Refer to SIR Warning . WARNING: Do not repair or replace the seat stitching or seams in the seat back trim cover with an internal mounted seat side airbag module. Replace the complete seat back trim cover from the OEM. Non-OEM seat stitching may cause improper airbag deployment which could result in personal injury. Preliminary Procedures SIR Disabling and Enabling Rear Seat Cushion Removal and Installation Fold the rear seat back to the downward position.
1	Rear Seat Back Bolster Fastener CAUTION: Refer to Fastener Caution . Remove the front seat belt buckle fastener. If a NEW threaded component is being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded component is reused, prepare the threaded component using the following steps: Remove any loose cured adhesive from the external threads of the component using a lint free cloth. Thread the cleaned component into the internal mating threads and remove to loosen trapped cured adhesive. Apply thread locking adhesive to the external threads of the component.Adhesives, Fluids, Lubricants, and Sealers (except GMNA) , or Adhesives, Fluids, Lubricants, and Sealers (GMNA) Ensure there are no gaps in the thread locking adhesive once applied to the component. Tighten 9 N.m (80 lb in)
2	Rear Seat Back Bolster Nut Tighten 9 N.m (80 lb in)
3	Rear Seat Back Bolster Procedure Disconnect the electrical connector.