Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Power Brake Master Cylinder Booster (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

Power Brake Booster Bolt (1) - Install and tighten [2x] 22 N.m (16 lb ft)
Connect the power brake master cylinder booster electrical connectors.
Brake Master Cylinder - Install - Brake Master Cylinder Replacement
Courtesy of GENERAL MOTORS COMPANY

Retainer (1) - Install NEW
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Ensure the locking tabs on the brake pedal retainer are fully engaged in the brake pedal arm.

Brake Pedal (1) - Connect
Brake Pedal Position Sensor - Install - Brake Pedal Position Sensor Replacement
Install the electric brake booster fuse to the engine compartment fuse block.
Bleed the hydraulic brake system. Hydraulic Brake System Bleeding (Pressure) , or Hydraulic Brake System Bleeding (Manual)
Program and calibrate the power brake booster control module. Control Module References