Front Seat Cushion Frame Replacement (Driver or Passenger Manual Seat)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
WARNING: Refer to SIR Warning . Preliminary Procedure Front Seat Cushion Cover and Pad Replacement
1	Driver or Passenger Seat Back Frame Fastener [4x] CAUTION: Refer to Fastener Caution . Remove the seat back frame bolts. If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps: Remove any loose cured adhesive from the external threads of the components using a lint free cloth. Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive. Apply thread locking adhesive to the external threads of the components. Adhesives, Fluids, Lubricants, and Sealers (except GMNA) , or Adhesives, Fluids, Lubricants, and Sealers (GMNA) Ensure there are no gaps in the thread locking adhesive once applied to the component. Tighten 45 N.m (33 lb ft)
2	Driver or Passenger Seat Cushion Frame Procedure Engage the seat adjuster locking retainer to keep the seat track locked in position during removal. Disconnect the electrical connector. Transfer components as necessary. Disengage the seat adjuster locking retainer to unlock the seat track after installation.

Callout

Component Name

WARNING:

Preliminary Procedure

Driver or Passenger Seat Back Frame Fastener [4x]

CAUTION:

Remove the seat back frame bolts.
If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps:
1. Remove any loose cured adhesive from the external threads of the components using a lint free cloth.
2. Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive.
3. Apply thread locking adhesive to the external threads of the components. Adhesives, Fluids, Lubricants, and Sealers (except GMNA) , or Adhesives, Fluids, Lubricants, and Sealers (GMNA)
4. Ensure there are no gaps in the thread locking adhesive once applied to the component.

Tighten
45 N.m (33 lb ft)

Driver or Passenger Seat Cushion Frame

Procedure

Engage the seat adjuster locking retainer to keep the seat track locked in position during removal.
Disconnect the electrical connector.
Transfer components as necessary.
Disengage the seat adjuster locking retainer to unlock the seat track after installation.