LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Equinox LS, FWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 6T40 (MNH MNK) Or 6T45 (MHG) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Transmission Mount Strut Replacement (Front Wheel Drive) >> Installation Procedure

Installation Procedure

  1. GM4663307Courtesy of GENERAL MOTORS COMPANY

    Using the outline made by the spray paint or marker, position the transmission strut (3) to the drivetrain and front suspension cradle.

    2. CAUTION:

    Refer to Torque-to-Yield Fastener Caution .

  2. Install the NEW transmission strut to bracket through bolt (1) and nut (2) then tighten to 100 N.m (74 lb-ft) plus 120 to 135 degrees.
  3. Perform the Powertrain Mount Balancing - Lower procedure. Refer to the appropriate engine section.
  4. Remove the jack stand.
  5. Install the transmission mount strut bracket. Transmission Mount Strut Bracket Replacement (Front Wheel Drive) 
scientia non olet · About LEMON Manuals