LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Equinox LS, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 248 (Automatic Transmission - 9T45 (M3U) Or 9T50 (M3D M3H) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Control Valve Body Assembly Removal (with ETRS) >> Control Valve Solenoid Body Wiring Harness Removal

Control Valve Solenoid Body Wiring Harness Removal

WARNING: This page is about a different car, the 2021 GMC Terrain. However, it is still accessible from the selected car via links, so may be relevant.
GM4572649Courtesy of GENERAL MOTORS COMPANY
Control Valve Solenoid Body Wiring Harness Removal

Callout Component Name
1 Control Valve Body Bolt [ 2x ] or [ 3x ]
NOTE:

Control valve body bolt quantity is wiring harness dependent.
2 Control Valve Solenoid Body Bolt
3 Automatic Transmission Wiring Harness

Procedure

  1. Ensure you disconnect all the connectors from the valve body.
  2. On-Vehicle the Variable Feed Solenoid Clutch Accumulator Piston and Spring may fall out. Control Valve Body Assembly Disassemble (with ETRS) 
NOTE:

The bolt retainer area on the wiring harness indicated by arrow may or may not be present. Newer design wiring harness does not have bolt retainer area.
4 Automatic Transmission Fluid Temperature Sensor Seal
Procedure 
Remove and DISCARD the seal.
scientia non olet · About LEMON Manuals