Removal Procedure
- Disable The Sir System. Sir Disabling And Enabling
Windshield Garnish Molding (1) - Remove [ 2X ] - Windshield Garnish Molding Replacement (Equinox)
Instrument Panel Outer Trim Cover (1) - Remove [ 2X ] - Instrument Panel Outer Trim Cover Replacement (Equinox)
Instrument Panel Outer Air Outlet - Left Side (2) - Remove - Instrument Panel Outer Air Outlet Replacement - Left Side (Equinox)
Instrument Panel Center Air Outlet - Left Side (2) - Remove - Instrument Panel Center Air Outlet Replacement - Left Side (Equinox)
Instrument Panel Center Air Outlet - Right Side (2) - Remove - Instrument Panel Center Air Outlet Replacement - Right Side (Equinox)
Instrument Panel Outer Air Outlet - Right Side (2) - Remove - Instrument Panel Outer Air Outlet Replacement - Right Side (Equinox)
Serial Data Gateway Module (1) - Remove - Serial Data Gateway Module Replacement (Equinox)
{ If Equipped } Instrument Panel Light Conductor Lamp (1) - Remove - Instrument Panel Light Conductor Lamp Replacement (Equinox)
Radio Control (1) - Remove - Radio Control Assembly Replacement (Equinox)
Front Floor Console Applique (1) - Remove - Front Floor Console Applique Replacement (Equinox)
Instrument Panel Compartment Door (1) - Remove - Instrument Panel Compartment Door Replacement (Equinox)
Radio Front Speaker (2) - Remove [ 2X ] - Radio Front Speaker Replacement (Equinox)
{ If Equipped } Radio Front Center Speaker (2) - Remove - Radio Front Center Speaker Replacement (Equinox)
{ If Equipped } Forward Collision Alert Display (3) - Remove - Forward Collision Alert Display Replacement (Equinox)
Hazard Warning Switch (1) - Remove - Hazard Warning Switch Replacement (Equinox)
Instrument Panel Airbag Bolt (1) - Remove [ 3X ]
- Disconnect The Electrical Connectors.
Instrument Panel Upper Trim Panel Bolt (1) - Remove [ 6X ]
Instrument Panel Upper Trim Panel Bolt (1) - Remove [ 3X ]
Instrument Panel Upper Trim Panel Bolt (1) - Remove [ 5X ]
Ignition And Start Switch (2) - Remove - Ignition And Start Switch Replacement (Equinox)
Turn Signal Switch (1) - Remove - Turn Signal Switch Replacement (Equinox)
Note The Location And Routing Of The Instrument Panel Wiring Harness Prior To Removal To Ensure Proper Installation.
- Disconnect The Electrical Connectors.
- Pull Rearward To Disengage The Clips.
- With The Aid Of An Assistant, Remove The Instrument Panel Upper Trim Panel (1) From The Vehicle.
- Transfer Components As Necessary.