Circuit/System Verification
- Verify the condition does not exist: Incorrect fluid level or condition
- If a condition exists
Repair or replace as necessary
- Go to next step: If no condition exists
- If a condition exists
- Ignition - On / Vehicle - In Service Mode
- Clear the DTCs.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify DTC P171D is not set.
- If the DTC sets
- Replace the component: Automatic Transmission Auxiliary Fluid Accumulator
- Road test the vehicle. Refer to: Road Test
Verify DTC P171D is not set.
- If the DTC sets - Refer to: Diagnostic Fault Information
- Go to next step: If the DTC is not set
- All OK.
- Go to next step: If the DTC is not set
- All OK.