Circuit/System Testing

Verify the condition does not exist: Incorrect pressure. Refer to: Line Pressure Check , & Solenoid Valve Pressure (Gen 3)
- If a condition exists
  Refer to: Fluid Pressure High or Low
- Go to next step: If no condition exists
Ignition/Vehicle - Off
Remove the component: Q8 Control Solenoid Valve Assembly
Verify the procedure/test passes. Refer to: Control Solenoid Valve and Transmission Control Module Assembly Solenoid Performance Test
- If the procedure/test does not pass
  Replace the component: Q8 Control Solenoid Valve Assembly
- Go to next step: If the procedure/test passes
Refer to: Diagnostic Fault Information