Removal Procedure
- Heater And Air Conditioning User Interface Control (1) - Remove - Heater And Air Conditioning User Interface Control Replacement (Equinox)
Radio Control Bracket Bolt (1) - Remove [ 2X ]
Radio Control Assembly (1) - Remove
- Use A Plastic Trim Tool If Necessary.
- Disconnect All Electrical Connectors.
Radio Control Bracket Bolt (1) - Remove [ 4X ]
- Radio Control Bracket (2) - Remove
Instrument Panel Upper Compartment Bolt (1) - Remove [ 4X ]
- Release The Retaining Tabs.
- Instrument Panel Radio Front Trim Plate (2) - Remove
- Transfer Components As Necessary.
Radio Control Bolt (1) - Remove [ 4X ]
- Instrument Panel Radio Rear Trim Plate (2) - Remove
- Transfer Components As Necessary.