Circuit/System Verification
- Ignition ON/Vehicle in Service Mode.
- Verify no Engine Control Module, Transmission Control Module (if equipped), Instrument Cluster DTCs, or communication DTCs are set.
- If any DTC is set
Diagnose DTCs first. Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Go to next step: If no DTCs are set
- If any DTC is set
- Verify the tachometer moves from the minimum to the maximum position and back to the minimum position when performing the Instrument Cluster Gauge Sweep Test with the scan tool.
- If tachometer does not sweep
Replace the P16 Instrument Cluster.
- Go to next step: If tachometer sweeps properly
- If tachometer does not sweep
- Refer to Circuit/System Testing.