Removal Procedure
WARNING:
Refer to Brake Fluid Irritant Warning .
CAUTION:
Refer to Brake Fluid Effects on Paint and Electrical Components Caution .
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Remove the rear tire and wheel assembly. Tire and Wheel Removal and Installation
- Clean all dirt and foreign material from the brake hose ends and the brake pipe fitting.
Rear Brake Pipe Fitting (1) @ Rear Brake Front Hose (2) - Remove
NOTE:Cap the brake pipe fitting to prevent brake fluid loss and contamination.
- Rear Brake Hose Clip (3) @ Rear Brake Hose Bracket (4) - Remove
Rear Brake Hose Fitting Bolt (1) @ Rear Brake Caliper - Remove
- Rear Brake Front Hose (2) @ Rear Brake Caliper - Remove
- Rear Brake Hose Washer (3) - Remove and DISCARD [ 2x ]NOTE:
These washers may be stuck to the brake caliper and/or the brake hose end.