Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution

Front Floor Console Cup Holder - Install
Front Floor Console Cup Holder Bolt (1) Install and tighten 3 N.m(27 lb/in)[ 7x ]
Courtesy of GENERAL MOTORS COMPANY

Rear Console Side Panel (1) - Left - Install
Rear Console Side Panel Bolt (1) Install and tighten 3 N.m(27 lb/in)[ 3x ]
Courtesy of GENERAL MOTORS COMPANY

Rear Console Side Panel (1) - Right - Install
Rear Console Side Panel Bolt (1) Install and tighten 3 N.m(27 lb/in)[ 3x ]
Courtesy of GENERAL MOTORS COMPANY

Armrest Hinge Reinforce Assembly-No. 2 (3) - Install
Armrest Hinge Reinforce Assembly-No. 2, Bolt (2) Install and tighten 3 N.m(27 lb/in)[ 2x ]
Armrest Hinge Reinforce Assembly-No. 2, Screw (1) Install and tighten 2 N.m(18 lb/in)[ 4x ]
Courtesy of GENERAL MOTORS COMPANY

Armrest Hinge Reinforce Assembly-No. 1 (2) - Install
Armrest Hinge Reinforce Assembly-No. 1, Bolt (1) Install and tighten 3 N.m(27 lb/in)[ 2x ]
Courtesy of GENERAL MOTORS COMPANY

Front Floor Console Cup Holder Trim Plate (3) - Install - Front Floor Console Cup Holder Trim Plate Replacement
Courtesy of GENERAL MOTORS COMPANY

Rear Floor Console Stowage Tray (2) - Install - Rear Floor Console Stowage Tray Replacement (without K4C) , or Rear Floor Console Stowage Tray Replacement (with K4C)
Courtesy of GENERAL MOTORS COMPANY

Front Floor Console Rear Trim Panel (1) - Install - Front Floor Console Rear Trim Panel Replacement
Courtesy of GENERAL MOTORS COMPANY

Rear Floor Console (1) - Install - Rear Floor Console Replacement