Removal Procedure
- Raise and support the vehicle. Lifting and Jacking the Vehicle .
- Prior to removing the mount, mark the mount fasteners to mount and mount to sub frame interfaces using spray paint or a marker for correct positioning during installation.
- Remove the two piece propeller shaft. Two-Piece Propeller Shaft Replacement .
- Using a suitable jack stand, support the rear of the powertrain.
- Remove the left and right side front cradle braces. Front Cradle Rear Brace Replacement
- Carefully lower the rear of the front suspension cradle to gain access to the transmission mount bracket bolts.
Remove the transmission mount to bracket through bolt (1).
- Remove and DISCARD the rear mount to drivetrain and front suspension cradle bolts (2).
- Remove the transmission rear mount.
NOTE:
The nuts are reusable.