Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0340, P0365 Condition 1
- DTC P0101, P0102, P0103 = Not set
- MAF Sensor = Greater than 1.5 g/s
Condition 2
- M64 Starter Motor = Active
- Camshaft Position Sensor = Signal received
Condition 3
- M64 Starter Motor = Inactive
- Engine = Running
Condition 4
- DTC P0335, P0336, P0641, P0651 = Not set
- M64 Starter Motor = Active
- Crankshaft = Synchronized
Condition 5
- DTC P0335, P0336, P0641, P0651 = Not set
- Crankshaft = Synchronized
Frequency the DTC runs = Continuously - After the running conditions are met
P0341, P0366 Condition 1
- DTC P0335, P0336, P0641, P0651 = Not set
- M64 Starter Motor = Active
- Crankshaft = Synchronized
Condition 2
- DTC P0335, P0336, P0641, P0651 = Not set
- Crankshaft = Synchronized
Frequency the DTC runs = Continuously - After the running conditions are met