Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

P0133, P1133

DTC P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0111, P0112, P0113, P0116, P0117, P0118, P0119, P0122, P0123, P0128, P0131, P0132, P0134, P0201, P0202, P0203, P0204, P0222, P0223, P0300, P0442, P0443, P0449, P0452, P0455, P0496, P16F3, P2101, P2135 = Not set
Barometric Pressure (kPa) = Greater than 70 kPa (10 PSI)
Deceleration Fuel Cut-Off = Inactive
Engine Coolant Temperature = Warmer than 60°C (140°F)
Engine Run Time = For greater than 30 s
Engine Speed = 1, 000 to 3, 500 RPM
Fuel Alcohol Content = Less than 87%
Fuel Control Loop Status = Closed Loop
Fuel level = Greater than 10%
HO2S Heater Resistance Learn Status = Valid
IAT Sensor = Warmer than -40°C (-40°F)
Ignition Voltage = Greater than 10 V
MAF Sensor = 8 to 60 g/s
Power Enrichment = Inactive
Scan Tool Device Control: = Not Activated
Vehicle Speed = 60 to 124 km/h (37 to 77 MPH)

Frequency the DTC runs = Once - Per drive cycle - After the running conditions are met - For greater than 2 s

P013A, P013E

DTC P0030, P0036, P0053, P0054, P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0111-P0114, P0116-P0118, P0120, P0121, P0122, P0123, P0125, P0128, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P013A, P013B, P013E, P013F, P0140, P0141, P0171, P0172, P0201-P0208, P0220, P0222, P0223, P0261, P0262, P0264, P0265, P0267, P0268, P0270, P0271, P0273, P0274, P0276, P0277, P0279, P0280, P0282, P0283, P0300-P0308, P0411, P0442, P0443, P0446, P0449, P0455, P0496, P0498, P0499, P1104, P1248, P1249, P124A - P124F, P1174, P1516, P16F3, P2100-P2103, P2119, P2135, P2147, P2148, P2150, P2151, P2153, P2154, P2156, P2157, P216B, P216C, P216E, P216F, P2176, P217B, P217C, P217E, P217F, P2270, P2271, P2440, P2444 = Not set
{P013A} DTC P013B, P013E, P013F, P2270, P2272 = Run & Passed
{P013E} DTC P2270 = Run & Passed
Engine Run Time = Greater than 5 min
Fuel level = Greater than 10%
HO2S Heater Resistance Learn Status = Valid
Ignition Voltage = Greater than 10 V

Frequency the DTC runs = Once - Per drive cycle - After the running conditions are met - Deceleration Fuel Cut-Off - Accelerator pedal not pressed.

P013B, P013F

DTC P0030, P0036, P0053, P0054, P0101, P0102, P0103, P0106, P0107, P0108, P0120, P0121, P0122, P0123, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P013A, P013B, P013E, P013F, P0140, P0141, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0442, P0443, P0446, P0449, P0455, P0496, P1133, P1174, P1516, P2101, P2119, P2135, P2176, P2270, P2271, P2A00 = Not set
{P013B} DTC P013A, P013E, P013F, P2270, P2271 = Run & Passed
{P013F} DTC P013A, P013E, P2270, P2271 = Run & Passed
Engine Run Time = Greater than 5 min
Fuel level = Greater than 10%
HO2S Heater Resistance Learn Status = Valid
Ignition Voltage = Greater than 10 V

Frequency the DTC runs = Once - Per drive cycle - After the running conditions are met

P015A, P015B

DTC P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 = Not set
Barometric Pressure (kPa) = Greater than 70 kPa (10 PSI)
Calculated Catalyst Temperature = 550 to 910°C (1, 022 to 1, 670°F)
Engine Speed = 1, 150 to 3, 500 RPM
Engine Coolant Temperature = Warmer than 60°C (140°F)
Engine Run Time = For greater than 30 s
EVAP Test = Not Running
Fuel Control Loop Status = Closed Loop
Fuel level = Greater than 10%
{Heated Oxygen Sensor = Greater than 690 mV} Deceleration Fuel Cut-Off = Active
HO2S 1 Heater Command = ON - For greater than 175 s
HO2S Heater Resistance Learn Status = Valid
IAT Sensor = Warmer than -40°C (-40°F)
Ignition Voltage = Greater than 10 V
MAF Sensor = 2 to 20 g/s
Scan Tool Device Control: = Not Activated
Vehicle Speed = 64 to 120 km/h (40 to 75 MPH)

Frequency the DTC runs = Once - Per drive cycle - After the running conditions are met

P2270

DTC P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P013A, P013B, P013E, P013F, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0411, P0412, P0418, P1174, P1516, P2101, P2119, P2135, P2176, P2271 = Not set
Accelerator Pedal Position = Less than 4%
Calculated Catalyst Temperature = 550 to 910°C (1, 022 to 1, 670°F)
Deceleration Fuel Cut-Off = Active
Engine Speed = 1, 150 to 3, 500 RPM
EVAP Test = Not Running
Fuel Control Loop Status = Closed Loop
Fuel level = Greater than 10%
HO2S 2 Heater Command = ON - For greater than 30 s
HO2S Heater Resistance Learn Status = Valid
Ignition Voltage = Greater than 10 V
MAF Sensor = 2 to 20 g/s
Vehicle Speed = 66 to 124 km/h (41 to 77 MPH)

Frequency the DTC runs = Once - Per drive cycle - After the running conditions are met

P2271

DTC P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P013A, P013B, P013E, P013F, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0411, P0412, P0418, P1174, P1516, P2101, P2119, P2135, P2176, P2270 = Not set
P013A, P013E, P2270 = Run & Passed
Fuel Control Loop Status = Closed Loop
Fuel level = Greater than 10%
HO2S Heater Resistance Learn Status = Valid
Ignition Voltage = Greater than 10 V

Frequency the DTC runs = Once - Per drive cycle - After the running conditions are met