Conditions for Running the DTC

• DTCs related to the following system/component = Not Set
  • B74 Manifold Absolute Pressure Sensor
  • B75 Mass Air Flow Sensor
  • B107 Accelerator Pedal Position Sensor
  • B150 Fuel Tank Pressure Sensor
  • B198 Fuel Composition Sensor
  • Q17 Fuel Injector
  • Q38 Throttle Body
  • Evaporative Emission (EVAP) System
  • Fuel Trim System
• Deceleration Fuel Cut-Off = Inactive
• Engine Run Time = For greater than 30 s
• Fuel Alcohol Content = Less than 87%
• Fuel Alcohol Content Learn In Progress = Inactive
• Fuel level = Greater than 10%
• Fuel Control Loop Status = Closed Loop
• Ignition Voltage = Greater than 10 V
• Scan Tool Device Control: = Not Activated

Frequency the DTC runs = Continuously - After the running conditions are met - For greater than 5 s