Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition/Vehicle & All vehicle systems - Off
- Disconnect the electrical connector: G18 High Pressure Fuel Pump
- Test for 0.3 to 0.7 ohms between the test points: Control terminal 1 & Control terminal 2
- If not between 0.3 and 0.7 ohms
Replace the component: G18 High Pressure Fuel Pump
- Go to next step: If between 0.3 and 0.7 ohms
- If not between 0.3 and 0.7 ohms
- Test for infinite resistance between the test points: Each terminal of the component & The component's housing
- If less than infinite resistance
Replace the component: G18 High Pressure Fuel Pump
- Go to next step: If infinite resistance
- If less than infinite resistance
- All OK.