LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Blazer RS, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Controls And Fuel - 2.5L (LCV) - Diagnostic Information And Procedures (1 Of 2)) >> Diagnostic Information and Procedures >> DTC P0090-P0092, P00C8, P00C9, or P00CA >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition - On / Vehicle - In Service Mode
  2. Perform the scan tool control function: Fuel Pressure Regulator - On and Off

    Verify the scan tool parameter:

    • Fuel Pressure Regulator Control Circuit High Voltage Test Status = OK or Not Run
    • Fuel Pressure Regulator Control Circuit Open Test Status = OK or Not Run
    • Fuel Pressure Regulator Control Circuit Low Voltage Test Status = OK or Not Run
    • Fuel Pressure Regulator High Control Circuit High Voltage Test Status = OK or Not Run
    • Fuel Pressure Regulator High Control Circuit Open Test Status = OK or Not Run
    • Fuel Pressure Regulator High Control Circuit Low Voltage Test Status = OK or Not Run
    • If not the specified state 

      Refer to: Circuit/System Testing

    • Go to next step: If the specified state 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  4. Verify the DTC does not set.
    • If the DTC sets 

      Refer to: Circuit/System Testing

    • Go to next step: If the DTC does not set 
  5. All OK.
scientia non olet · About LEMON Manuals