LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Blazer RS, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Controls And Fuel - 2.0L (LSY) - Repair Instructions) >> Repair Instructions >> Fuel Pressure Gauge Installation and Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Relieve the fuel system pressure. Fuel Pressure Relief 
  2. GM5042975Courtesy of GENERAL MOTORS COMPANY

    Remove the J-34730-1A  Fuel Pressure Gauge (1).

  3. Disconnect the quick connect coupling of the CH-37287-1A  Fuel Pressure Gauge Adapter from the fuel feed pipe and the fuel pump. Use a shop towel in order to catch any remaining fuel that may leak. Metal Collar Quick Connect Fitting Service 
  4. Connect the quick-connect fitting of the fuel feed pipe and the fuel pump. Metal Collar Quick Connect Fitting Service 
  5. Turn ON the ignition in order to pressurize the fuel system.
  6. Turn OFF the ignition.
  7. Check for any fuel leaks.
scientia non olet · About LEMON Manuals