Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Use appropriate tool to remove old sealant. Inspect the threads on the water pump outlet pipe for damage.
- Apply a thin layer of sealant to the engine coolant temperature sensor (1). Adhesives, Fluids, Lubricants, and Sealers
- Engine Coolant Temperature Sensor (1) - Install and tighten 9 N.m (80 lb in)
Engine Coolant Temperature Sensor Electrical Connector (2) - Connect
- Fill the cooling system. Cooling System Draining and Filling (Static LSY) , or Cooling System Draining and Filling (GE 47716 LSY)
- Start the engine and check for leaks.
CAUTION:
Refer to Component Fastener Tightening Caution .