LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Blazer RS, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Power Transfer Unit AAM) >> Repair Instructions - On Vehicle >> Output Shaft Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the propeller shaft. Two-Piece Propeller Shaft Replacement
  2. GM4288034Courtesy of GENERAL MOTORS COMPANY

    Remove and Discard the propeller shaft retainer (1).

  3. Remove and Discard the propeller shaft O-ring (2).
    4. NOTE:

    Use a suitable flat bladed tool to remove the seal from the housing. Use care to prevent damage to the housing seal bore or shaft sealing surface.

  4. Remove and Discard the transfer unit output seal (3).
scientia non olet · About LEMON Manuals