Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Apply clean engine oil to the valve stems and hydraulic valve lash adjusters as indicated by the arrows. Adhesives, Fluids, Lubricants, and Sealers
- Apply clean engine oil to the valve rocker arm roller bearings. Adhesives, Fluids, Lubricants, and Sealers
- NOTE:
Used rocker arms must be returned to the original position on the camshaft. If the camshaft is being replaced, the valve rocker arms actuated by the camshaft must also be replaced.
Valve Rocker Arm (1) - Install [8x]
Install the intake camshaft position actuator (1) and camshaft (2). Camshaft Position Actuator and Intake Camshaft Replacement