Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- NOTE:
Use a suitable tool to route the sensor connector through the oil pan opening.
Engine Oil Level Indicator Switch (1) - Install
Engine Oil Level Indicator Switch (1) @ Oil Pump Flow Control Solenoid Valve Wire Clip (2) - Install
- NOTE:
Pull the sensor connector (2) through the connector opening and ensure that it is properly seated.
Engine Oil Level Sensor Lead Clip (1) - Install
- CAUTION:
Refer to Fastener Caution .
Engine Oil Level Indicator Switch Bolt (2) - Install and tighten [2x] 10 N.m (89 lb in)
- Electrical Connector (1) @ Engine Oil Level Indicator Switch - Connect
Lower Oil Pan (3) - Install - Lower Oil Pan Replacement