Measuring Cylinder Bore Diameter
WARNING: This page is about a different variant/trim than selected.
Check the cylinder condition. Some light vertical marks may be visible on the cylinder wall. In these areas, check that the honing marks are still visible in this marked area. If they are, the cylinder surface has not been compromised and the engine block can be used.
- Measure the cylinder bore diameter 35 mm (1.378 in) from the deck face using a commercially available bore gauge.
- Compare your results with the Engine Mechanical Specifications . If the cylinder diameter exceeds the specifications, replace the engine block.
NOTE:
A commercially available bore gauge with dial indicator graduations in ten thousandths inch (0.0001") is necessary for measuring engine specification range.