Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Apply clean engine oil to all lobes and journals prior to installing the camshafts. Adhesives, Fluids, Lubricants, and Sealers
Install the exhaust camshaft (1) and exhaust camshaft actuator (2).
- Set the exhaust camshaft on top of the roller followers in the camshaft bearing journals with the exhaust actuator timing mark at approximately the one O'clock position.
Align and install the EN-50793 Camshaft Actuator Retainer (1) into the slots of the exhaust camshaft actuator.
- Mount the EN-50793 Camshaft Actuator Retainer (1) to engine front cover and tighten the 2 bolts (2) to 10 N.m (89 lb in).
Camshaft Position Actuator Bolt (1) - Install NEW - Camshaft Assembly Assemble
Camshaft Bearing Cap (2) - Install [4x] - Intake and Exhaust Camshaft, Bearing Cap, and Lash Adjuster Installation
- Camshaft Bearing Cap Bolt (1) - Install [8x] - Intake and Exhaust Camshaft, Bearing Cap, and Lash Adjuster Installation
Camshaft Bearing Cap (2) - Install - Intake and Exhaust Camshaft, Bearing Cap, and Lash Adjuster Installation
- Camshaft Bearing Cap Bolt (1) - Install [2x] - Intake and Exhaust Camshaft, Bearing Cap, and Lash Adjuster Installation
Timing Chain Guide (3) - Install
- Timing Chain Guide Bolt (2) - Install - Intake and Exhaust Camshaft, Bearing Cap, and Lash Adjuster Installation
- Camshaft Bearing Cap Bolt (1) - Install - Intake and Exhaust Camshaft, Bearing Cap, and Lash Adjuster Installation
Remove the EN-50656 Timing Chain Retainer (1).
- Vacuum Pump - Install - Vacuum Pump Replacement
- Camshaft Cover - Install - Camshaft Cover Replacement